Mazda 2003 MPV User Manual download pdf (Page 41)

MA42

Mazda ReferenceMA000

3. Verify following conditions and correct if necessary:

– All accessory loads (A/C, headlights, blower fan, rear window defroster) are off.

– Initial ignition timing and idle speed are within specifications.

4. Verify that the following PIDs are within specifications:

– BARO: 21.2 inHg (72.2 kPa, 541 mmHg) or higher

– IAT: 41°F to 95°F (5°C to 35°C)

– FTL: 15% to 85%

– VPWR: 10.9V to 14.6V

NOTE:

i All PIDs must be within specifications from Step 5 to Step 6

5. With vehicle stopped, race engine at RPM indicated, then drive vehicle as shown in

Figure MA000-37. Driving conditions before driving at constant speed are not specified. If

possible, monitor RPM PID for engine speed during this procedure.

Figure MA000-37

6. Stop the engine.

Table MA000-4

Step Time

Engine Speed Vehicle Speed

Condition

Step RPM Step MPH(KPH)

T1 More than 15 seconds N1 2500 to 3500 — 0 —

T2 More than 60 seconds N2 Idle — 0

Idle engine after cooling

fan stops

T3 More than 5 hours — 0 — 0 Keep key off

T4 More than 15 minutes — Idle V1 0 —

T5 5 minutes — — V2 40–50 (65–80)

Transmission in D range

T6 1 minute V3 49–57 (79–91)

T7 1 minute V4 Above 40 (64)

T8 3 minutes V5 45–55 (72–88)

T9 More than 10 minutes — 0 — 0 Keep key off

TIME

ENGINE SPEED

Key

Off

Start

Engine

System Repair Verification Drive Mode (EGR, HO2S Heater, HO2S, TWC, and EVAP)

Stop

Engine

VEHICLE SPEED

Start

Engine

Idle

Start

Engine

Stop

Engine

Note: See table below for segment times and speeds.

Vehicle Stopped Vehicle Moving

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Comments to this Manuals

No comments

Mazda 2003 MPV User Manual Page 41

Comments to this Manuals

Related products and manuals for Cars Mazda 2003 MPV