Mazda 2003 MPV User Manual download pdf (Page 11)

MA12

Mazda ReferenceMA000

Figure MA000-16

NOTE:

i All parameters must be within specification before the engine is started in order to initiate the

EVAP system test.

3. Clear any DTCs from PCM memory.

4. Start the engine and run it at 3500 RPM for at least 200 seconds until it is completely

warmed up. Then, run at idle for 120 seconds.

5. Stop the vehicle, switch the key off, then access the OBD-II Readiness Monitor with the

scan tool to inspect the completion status. If not completed, turn the ignition key off and

go back to Step 1.

6. Verify that no DTCs have been set.

MODE 6—EVAP System Repair Verification Drive Mode

This mode applies to the following models:

• 2002–04 MPV

z To perform this Mode 6 drive cycle:

1. Switch all electrical accessories off.

2. Verify the following parameters are within the listed specifications:

– BARO—21.3 in-Hg (542 mm-Hg, 72.3 kPa) or higher.

– IAT—41 to 95°F (5 to 35°C).

– FTL (fuel tank level):

2002–03 model = 0.5 to 2.5V

2004 model = 15% to 85% full.

– VPWR (vehicle power)—10.9 to 14.6V.

NOTE:

i All parameters must be within specification before the engine is started in order to initiate the

EVAP system test.

3. Clear any DTCs from PCM memory.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 48 49

No comments

Mazda 2003 MPV User Manual Page 11