MA16
Mazda ReferenceMA000
– The drive mode conditions must be met within 4 to 10 minutes after start up. If the
time exceeds 10 minutes, switch the ignition OFF to reset the timer, then restart.
– After monitor conditions are set, system testing requires at least 30 seconds.
– Fuel tank pressure will change as shown in the illustration during monitoring
(Figure MA000-20).
Figure MA000-20
2. Turn off all accessories (A/C, headlights, blower fan, etc.).
3. Drive vehicle as indicated by the graph (Figure MA000-21).
4. Stop vehicle and access the OBD-II Readiness Monitor to check completion status.
5. If not completed, turn the ignition key to OFF and repeat entire process.
6. Verify that no DTCs have been set.
Figure MA000-21
Comments to this Manuals