Mazda 2003 MPV User Manual download pdf (Page 40)

MA41

Mazda ReferenceMA000

4. Stop the vehicle and access ON BOARD SYSTEM READINESS to verify monitor status:

– If completed, OBD monitoring status items change to read completed.

– If not completed, turn key off, then repeat from Step 3.

5. Access DIAGNOSTIC MONITORING TEST RESULTS to verify monitoring results.

– If detected values are not within specification, repair has not been completed.

6. Verify no DTCs set.

Mode 6 (EVAP System Repair Verification Drive Mode)

NOTE:

i If “EVAP System Repair Verification Drive Mode” cannot be performed (you cannot drive the

vehicle under specified conditions), perform evaporative system test procedure as an

alternative. (See “Evaporative System Test” in “Test and Procedures” section of Driveability

Troubleshooter.)

z To perform this drive mode:

1. Verify that the following PIDs are within specifications. All PIDs must be within

specifications before engine is started to initiate evaporative system test:

– BARO: 21.2 inHg (72.2 kPa, 541 mmHg) or higher

– IAT: 41°F to 95°F (5°C to 35°C)

– FTL: 15% to 85%

– VPWR: 10.9V to 14.6V

2. Clear DTCs from PCM memory.

3. Start the engine and idle for 10 seconds or more, then turn key OFF.

4. Leave vehicle in this condition for 5 hours or more.

5. Start engine, and idle for 15 minutes or more.

6. Drive the vehicle at 40mph to 50mph (65km/h to 80km/h) for 5 minutes or more.

7. Stop the vehicle and turn the key OFF.

8. Leave vehicle in this condition for 10 minutes or more.

9. Start the engine.

10. Stop the vehicle and access ON BOARD SYSTEM READINESS to verify monitor status:

– If completed, OBD monitoring status items change to read completed.

– If not completed, turn key off, then repeat from Step 3.

11. Access DIAGNOSTIC MONITORING TEST RESULTS to verify monitoring results:

– If detected values are not within specifications, repair has not been completed.

12. Verify no DTCs set.

Single Drive Mode (PCM Adaptive Memory Produce, EGR System,

HO2S heater, HO2S, TWC, and EVAP System Repair Verification)

z To perform this drive mode:

1. Start the engine and warm completely.

2. Clear DTCs from the PCM memory.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 48 49

No comments

Mazda 2003 MPV User Manual Page 40