MA29
Mazda ReferenceMA000
Mode 2 (EGR System Repair Verification Drive Mode)
z To perform this drive mode:
1. Perform “PCM Adaptive Memory Produce Drive Mode” first.
2. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
3. Drive the vehicle as shown in Figure MA000-27.
Figure MA000-27
4. Stop vehicle and access ON BOARD SYSTEM to verify OBD monitoring status:
– If completed, OBD monitoring status items change from non-completed to
completed.
– If not completed, turn key off, then repeat from Step 3.
5. Access DIAGNOSTIC MONITORING TEST to verify monitoring results.
– If detected values are not within specifications, repair has not been completed.
6. Verify no DTCs set.
Mode 3 (HO2S heater, HO2S, and TWC Repair Verification Mode)
z To perform this drive mode:
1. Perform “PCM Adaptive Memory Produce Drive Mode” first.
2. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
3. Drive vehicle as shown in Figure MA000-28.
TIME (Seconds)
VEHICLE SPEED
Idle
Key
Off
Start
Engine
More
Than
60 sec.
49 to 57 mph (79 to 91 kph):
MTX in 5th Gear,
ATX in D Range
Mode 2 (EGR System Repair Verification Drive Mode)
Comments to this Manuals