MA24
Mazda ReferenceMA000
3. Drive vehicle as shown in Figure MA000-24.
Figure MA000-24
4. Stop the vehicle and access ON BOARD SYSTEM READINESS to verify monitor status:
– If completed, OBD monitoring status reads completed.
– If not completed, turn the key off, then repeat from Step 3.
5. Access DIAGNOSTIC MONITORING TEST to verify monitoring results.
– If detected values are not within specifications, repair has not been completed.
6. Verify no DTCs set.
HO2S heater, HO2S, and TWC Repair Verification Drive Mode
z To perform this drive mode:
1. Perform “PCM Adaptive Memory Production Drive Mode” first.
2. Verify all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
3. Drive the vehicle as shown in Figure MA000-25.
TIME (Seconds)
VEHICLE SPEED
Idle
Key
Off
Start
Engine
More
Than
60 sec.
49 to 57 mph (79 to 91 kph):
MTX in 5th Gear,
ATX in D Range
EGR System Repair Verification Drive Mode
Comments to this Manuals