1.3L ENG SECONDARY AIR CONTROL SYSTEM MODIFICATION CA
Checking Port Air Switching Valve:
1. Warm up the engine and run it at idling speed.
2. Connect a tachometer to the engine.
3. Disconnect the connector from the throttle sensor and connect a
jumper wire to A and C terminals of the connector.
Fig. 4: Jumper Wire Installation
4. Connect a voltmeter to the port air switching valve (R) terminal
and ground.
5. Increase the engine speed and observe the voltmeter reading.
Engine Speed (rpm) Voltage (V)
Idling speed - 3.000 approx. 12
3,000-4,000 below 2
more than 4.000 approx. 12
6. Disconnect the jumper wire connected in step 3 and connect the
connector to the throttle sensor.
Fig. 5: Voltmeter Connections
7. Position the vehicle on a rolling-road tester. See Fig. 6
WARNING: Use wire rope to secure the vehicle so it doesn't move
Comments to this Manuals