E8
THERMOSTAT, WATER PUMP
THERMOSTAT INSPECTION
A6E361815171W02
1. Inspect the thermostat for the following.
• Closed valve in room temperature
• Opening temperature and lift of the valve
If not as specified, replace the thermostat.
End Of Sie
WATER PUMP REMOVAL/INSTALLATION
A6E362015010W01
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See E3 COOLING SYSTEM SERVICE WARNINGS.) (See E3 ENGINE
COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See B3 DRIVE BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Refill the engine coolant. (See E3 ENGINE COOLANT REPLACEMENT.)
7. Inspect the engine coolant leakage. (See E4 ENGINE COOLANT LEAKAGE INSPECTION.)
Initial-opening temperature
80.084.0 {176183.2}
(°C {°F})
Full-open temperature
97 {206.6}
(°C {°F})
Full-open lift (mm {in}) More than 8.0 {0.31}
WATER PUMP
AME3620W001
1 Water pump pulley
2 Water pump
Comments to this Manuals