Mazda GENUINE SIDE UNDER SPOILER User Manual download pdf (Page 3)

─３─

CAUTION

Be sure to cover the

vehicle body with

protectors or mats to

prevent stains, scratches

and damage when

removing/installing the

vehicle parts

Use the most appropriate

(size, use) tool for each task

and perform the work

correctly.

Otherwise, the parts may

be damaged.

When installing parts with

double-sided adhesive

tape, carefully clean the

adhesive surface and keep

it away from dust or dirt.

Otherwise, parts could fall

off and be damaged.

Place the removed parts

and kit accessories on a

protective sheet to prevent

scratches.

NOTE

• Refer to the Workshop Manual for removal and installation of vehicle parts. Not following the procedures for

removal/installation in the Workshop Manual could result in an accident or vehicle malfunction.

Fastener removal

1. Remove the fastener (1).

(For vehicles with mudflaps, remove the fasteners (2), and then

the mudguard)

Hole cover removal

1. Remove the hole covers from the lower surface of the side sill panel

using a flathead screwdriver wrapped with protective tape as shown

in the figure (1st, 6th, 11th hole covers from vehicle front).

3. BEFORE INSTALLATION

• The removed fasteners are not used to install this accessory.

4. PART REMOVAL

• The figure shows the right side, however, perform the same

procedure for the left side.

NOTE

• The side under spoiler installation work requires two or more people.

• The side under spoiler and the mudguard cannot be equipped together.

CAUTION

NOTE

• The removed hole covers are not used to install this

accessory.

NOTE

Hole cover

Vehicle fron

Side-sill

panel lower

surface

2 3 45 6 7 8 9 10 11

Fastener

Vehicle fron

Mudguard

Remove this fastener

(Vehicles with mudflaps)

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Mazda GENUINE SIDE UNDER SPOILER User Manual Page 3

Comments to this Manuals

Related products and manuals for Motor vehicle electronics Mazda GENUINE SIDE UNDER SPOILER