Mazda 2005 Mazda6 Owner's Manual download pdf (Page 10)

HOMELINK

®

Always check the Owner’s Manual for more operating information and safety features

HomeLink

®

Driving

Tips

Quick Tips 2005 Mazda6 page 18

page 19

Auto-dimming rear

view mirror

Auto-dimming function changes

are based on outside lighting

conditions and if bright headlights

are visible in rear view mirror

Press on (2), off (3)

ABS self test

A self-diagnostic test is performed

when starting; you may feel some

brake pedal pulsation and hear

some noise, this is normal

Traction Control System (TCS)

Enhances traction and safety by

regulating engine torque

When TCS detects drive wheel

slippage it lowers engine torque

to prevent loss of traction

Rolling code synchronization

procedure

Refer to your garage door opener or

device instruction manual to confirm

your system is equipped with a

rolling code feature

Tip: This procedure is easier

to perform with the assistance

of another person

To synchronize: Press programming

button on garage door opener

motor; press/hold for 2 seconds

and release the programmed

HomeLink

®

button 2 times

within 30 seconds of pressing

the garage door opening

motor programming button

Some devices may require you

to press/hold and release a

third time to complete

programming procedure

If indicator light stays on,

programming is complete

To erase all existing programming;

press and hold two outer

HomeLink

®

buttons (1) on mirror,

continue to hold buttons until

indicator light flashes

Anti-lock Braking System (ABS)

ABS automatically reduces

hydraulic pressure to any wheel

on the verge of locking up

You may feel a slight pulsing of

the brake pedal and hear a

clicking noise; this tells you the

ABS is functioning properly;

increase pressure on pedal for

maximum braking

Tips: Maintain constant

pressure on the brake pedal

Do not pump the brakes

To program or reprogram:

Press and hold two outer

HomeLink

®

buttons (1) for 20

seconds and no more than

30 seconds, release only after

indicator light (4) begins to

flash; hold transmitter for the

device to be programmed

between 1-3 inches to

HomeLink

®

; press transmitter

button and desired HomeLink

®

button (1) simultaneously until

HomeLink

®

indicator light (4)

goes from slow to rapid flashing

Verify device operation by

pressing HomeLink

®

button (1)

that was just programmed

Tip: You do not need to repeat

the first step to program the

other two hand-held transmit-

ters for the remaining

HomeLink® buttons

For further information, contact

HomeLink

®

at 1-800-355-3515,

www.homelink.com or your

authorized Mazda Dealer

Gas cap

After filling vehicle with gasoline,

fully reinstall gas cap by turning

clockwise until a clicking sound is

heard, if gas cap is not fully

installed, Check Engine light

may come on

For more information on Check

Engine light, see Owner’s Manual

HomeLink

®

Wireless

Control System*

Located on rear view mirror

HomeLink

®

provides three

programmable buttons that

will replace three hand-held

device transmitters

Tip: It is recommended to

park outside of garage when

programming HomeLink

®

WARNING: When programming

a garage door or gate opener,

disconnect power to these

devices before programming,

continuous operation of these

devices could damage the motor

*Denotes optional equipment

11 4 2 3

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments