Mazda 0000-8F-N02B Owner's Manual download pdf (Page 3)

4280159 Rev. A 10/10

VEHICLE PREPARATION

1. Disconnect and Remove Battery

a. Disconnect and isolate the negative and positive battery

terminals. (FIGURE A)

b. Remove battery hold-down bracket assembly by loosen-

ing both 10 mm nuts and pivoting lower retainers toward

vehicle dashwall. (FIGURE A)

c. Carefully remove the battery from vehicle.

2. Remove the following components:

a. Using a fiber stick, remove the driver’s side scuff plate.

The scuff plate is held by 3 clips. (FIGURE B)

10 mm

Socket

FIGURE A

FIGURE B

ELECTRICAL SYSTEM GENERAL PROCEDURES; continued

Wire Tie Procedure

Tapered End

Wire Tie Head

1.Wrap wire tie around

the harnesses you

wish to secure

together.

2.Insert the Tapered

End of the wire tie

into the Wire Tie

Head.

3.Pull the Tapered End

through the Wire Tie Head

until the wire tie is snug.

4.Trim wire tie end

after tightening.

1 2 3 4 5 6 7 8 ... 25 26

No comments

Mazda 0000-8F-N02B Owner's Manual Page 3