Mazda Navigation system Technical Information download pdf (Page 6)

Switching on and off

Your Mazda NB1 switches on when your car engine starts and switches off automatically when you

turn off your car's engine.

Until a connection has been established between the main device and the Mazda NB1, the screen

shows audio-related information and the Navi button on the main display is inactive. In the case of a

cold boot of the navigation device, press the Navi button. A black screen is shown and it make take up

to 30 seconds for the main screen to appear.

Under extreme temperature conditions, the navigation device may not start. When the temperature is

within the normal range again, the device should start. If the device fails to start automatically in this

situation, stop your car engine and start the car engine again.

Note: In some situations, your navigation system may restart when turning your key in the ignition

from ACC-ON to the engine start position. If this happens, it may take up to 30 seconds for the main

screen to appear on the navigation system.

Setting up

Important: Take care to select the correct language as the language you choose will be used for all

text on the screen.

When you first switch on your device, you have to answer a few questions to set up the device.

Answer the questions by tapping the screen.

GPS reception

When you first start your Mazda NB1 navigation device, the device may need a few minutes to

determine your GPS position and show your current position on the map. In future, your position will

be found much faster, usually within a few seconds.

In areas where GPS reception is not possible, such as tunnels, your location may not be accurate.

Important: The GPS antenna is located in the dashboard so do not put objects on the dashboard.

Device not starting

In rare cases, your TomTom navigation module may not start correctly or may stop responding to your

taps. For example, if the device temperature is too high or too low, the system shuts down.

In rare circumstances, you may need to reset your navigation device. To reset your device, switch off

the car engine and then remove the memory card. Re-insert the memory card and switch the car

engine on again.

Take care of your device

It is important to take care of your device as follows:

Read me first

1 2 3 4 5 6 7 8 9 10 11 ... 84 85

No comments

Mazda Navigation system Technical Information Page 6